Why isn’t the lens processing finished?<\/strong><\/p>\n Right Side – Contact Switch<\/p>\n The contact switch is a component in the Lens Edger that detects the position of the lens. In order for the Lens Edger to accurately process the lens, the lens must first be in the correct position. The contact switch detects this position and sends a signal to the equipment to ensure that the lens is in place. However, if the contact switch is not functioning properly due to dust or foreign particles, it may fail to detect the lens’s position accurately, leading to the phenomenon where the initial processing does not stop and continues.<\/p>\n <\/p>\n When Processing Isn’t Completed<\/p>\n Super Simple Solution<\/p>\n <\/p>\n When this happens, simply cleaning the contact switch to remove any debris can easily resolve the problem. All you need is a lens cloth or a soft fabric cloth!<\/p>\n <\/p>\n First, open the edger cover and secure it so it does not close.<\/p>\n Second, use a flathead screwdriver to turn the Y-axis screw and lower it sufficiently.<\/p>\n Third: Gently lift the carriage section and secure it with an appropriately sized object to prevent it from falling.<\/p>\n Fourth: Locate the contact switch on the left side and use a soft cloth, like a lens cloth, to remove any dust.<\/p>\n![\"\"](\"https:\/\/huvitz2025.mycafe24.com\/wp-content\/uploads\/2025\/01\/KakaoTalk_20250114_150637076_02.jpg\")
<\/a><\/p>\n<\/a><\/p>\n<\/a><\/a><\/p>\n